Baumatic BHC770SS Instruction Manual page 27

* The safety cut out has been triggered. Press the ON/OFF button
to reset the hob.
* Check that the mains electrical supply to the appliance is correct
and working. Check the mains fuse.
o The residual heat indicator has not come on after I have
switched a cooking zone off.
* The cooking zone has only been turned on for a short period of
time; therefore it did not go above 60°C.
* IMPORTANT: If the cooking zone does appear to be hotter than
60°C and the residual heat indicator has not come on, you
should call the Customer Care Department.
o A humming sound is heard when a cooking zone is
selected.
* This is normal; the sound will disappear when the zone heats up.
o The cooking zones have become discoloured.
* This maybe caused by burnt on remnants of food. This will not
affect the working of the appliance. However you should make
sure that the cleaning instructions are being followed regularly.
Error codes
If an error code appears on the hob display, please refer to the table
below to see if the problem can be easily rectified:
Error code
ER03 * Permanent use of the
permanent keys; control unit cuts
alarm tone off after 10 seconds.
ER25 Secondary voltage of
the power supply unit
too high
(primary>300V).
Control switches off
and a permanent
acoustic signal is heard.
ER33 Water on the glass above the control
Description Possible Error clearing
error cause
Water or Cleaning of the
cooking operational
utensils on surface.
the glass
above the
control unit.
Control is Connect to the
wrongly correct mains
connected. voltage.
Clean
solution
27