Filters
1.
Open the front panel.
2.
Remove the air fi lter.
•
Press the claws on the right and left of the air fi lter down slightly, then pull upward.
3.
Take off the titanium apatite photocatalytic
air-purifying fi lter.
•
Hold the tabs of the frame, and remove the claws in 4 places.
4.
Clean or replace each fi lter.
See fi gure.
5.
Set the air fi lter and titanium apatite photocatalytic air-purifying
fi lter as they were and close the front panel.
•
Operation without air fi lters may result in troubles as dust will accumulate inside the indoor unit.
•
Insert the 2 tabs on the lower side of air fi lter into the body.
•
Then, insert the 2 tabs on the upper side into the body.
•
Insert the tab on the right side into the body.
•
Close the panel slowly.
•
Slide the 2 stoppers on the left and right sides
outward until they click.
CAUTION
•
Do not touch the aluminum fi ns by bare hand at the time of dismounting or mounting the fi lter.
Page 26
Titanium apatite
photocatalytic
air-purifying filter
Air filter
27