Water Drainage - Westinghouse WWT9084C7SA User Manual

38 www.westinghouse.com.au / www.westinghouse.co.nz
If you only have a cold water tap, you
must remove the inlet hose with the RED
ends from the washing machine and fit a
blank cap with a sealing washer to the
HOT water inlet valve, otherwise water
will leak out of the valve.
NOTE: With cold water tap only, you
must only select cold water tempera-
tures.
A blank cap is available in the manual
bag.

10.4 Water Drainage

1. Fitting hose former.
Obtain hose former from inside the
washbowl and fit it to the drain hose.
Pull apart to
insert hose.
Hose
Guide
pull hose
Adjust length to suit
trough.
2. Positioning of drain hose.
Adjust the free length of hose to suit
your installation.
It is important that the top of the
drain hose is above the joint
between the washing machine
cabinet and the top panel (see
picture).
Adjust this
length to
suit your
trough.
Trough
Please refer to the installation
instruction sheet, for more
information.
bend
hose
Top of drain hose must be
above the join (arrowed)
between the top panel and
the cabinet.