Assembly Instructions (Cont.)
If using your own supplied lid, put Cyclone (A) and lid on
4
top of your dust container and seal it airtight [FIG. 4a].
If using the provided Lid (E), snap Cyclone (A) and Lid
assembly onto your bucket and ensure it's fully seated [FIG.
4b]. The Lid will make an audible click as it seals close.
Note: The Lid (E) may fit loosely on your bucket. This is
normal. The lid will seal shut under vacuum pressure once
you turn on your wet/dry vacuum. To empty the bucket, lift
up on the Lid's latch and pull up on the Lid to release the Lid/
Cyclone assembly from the bucket [FIG. 4c].
FIG. 4a
FIG. 4b
FIG. 4c
8
Oneida Air Systems