Oneida Air Systems Dust Deputy 2.5 D.I.Y. Manual page 6

Assembly Instructions
For the 2.5 Plus (#AXD250504), continue to Step 3.
1
Draw a 3" diameter circle on your supplied lid. Carefully
cut out 3" hole in lid. Use 5/16" drill bit to drill bolt holes.
Note: Use the base of the Cyclone (A), Gasket (B), or the Dust
Deputy Template on page 14 for reference.
Turn Cyclone (A) upside-down. Place Gasket (B) on the
2
base of Cyclone (A) and align all the holes. Place the topside
of your supplied lid against Gasket (B) and align all the
holes. Secure Cyclone (A), Gasket (B) and lid together using
six Bolts (C1), six Washers (C2), and six Whiz-Lock Nuts
(C3) as shown in [FIG. 2].
Note: Tighten hardware evenly to eliminate air leaks.
6 Oneida Air Systems
FIG. 1
FIG. 2
C3
C2
C1