Frequently Asked Questions - Quantum Scalar 10K User Manual

Frequently Asked Questions

6-42 Error Messages
This section provides a reference of commonly asked
questions and their answers.
Question: How do I set the SCSI ID of the Scalar 10K?
Answer: The SCSI ID of the Scalar 10K can be set via the
operator panel. Refer to SCSI Submenu on page 4-
66.
Question: How do I get a password to use Capacity On
Demand?
Answer: Contact GCH to receive a password, and refer to
Capacity Submenu on page 4-79.
Question: What is the Element Addressing scheme for the
Scalar 10K?
Answer: The host references source and target
designations with element addresses within
the Scalar 10K library. Each element within
the library has a unique address. For
further information refer to Element Addressing on
page 2-5 of the Scalar 10K SCSI Reference Manual.
Question: What is the difference between Default mode,
Extended mode, and Multi Media mode?
Answer: The Scalar 10K can recognize different types of
barcode labels, depending on what mode it is
operating in. Refer to Understanding Barcodes on
page 5-12.
Question: How do I upgrade the library firmware?
Answer: The Scalar 10K library firmware may only be
upgraded by trained personnel. Contact GCH.
Question: What do I do if I lose my password?
Answer: Contact GCH. They can tell you how to reset the
password.
Question: What are the barcode limitations/restrictions?
Answer: Barcode labels must be printed according to
certain specifications. Refer to Barcode Labels on
page 5-12.
6-00058-05 Rev A