Crown WBT36 Operator's Safety And Service page 37

www.crownequip.com
(204) 831 8468
when starting can cause uncontrolled handle movement that can cause serious injury.
The handle must not move while pulling the engine recoil starter.
• Visually check to be sure that the blades are free of obstructions and the area is clear
for operation. For trowels that use this feature, ensure that the emergency stop switch
is in the ON position.
• Move the throttle to the idle position.
• Switch the engine ON/OFF switch to the ON position.
• Never place your foot on the ring guard when starting the engine or severe injury can
occur if your foot slips through the ring guard as the blades start to spin.
• While firmly holding the handle with one hand, start the engine following the guidelines
in the engine manufacturer's instruction manual.
• Hold the handle bar firmly with both hands while the trowel is "throttled-up".
• If control of the trowel is lost, stay clear and do not attempt to regain control until the
trowel has stopped moving. Depending on the engine speed, the trowel handle can swing
around before it stops completely.
• You are ready to operate the trowel!
RIDE-ON TROWELS
• Ensure that the operator is familiar with the trowel and is trained on its operation.
• ensure they are functioning and their readings are within the manufacturer's normal
operating range.
• Ensure the operator is well rested and not fatigued, is alert, and not impaired in any way
(medications, drugs, alcohol, etc.).
• Adjust the seating if necessary and get into a • You are ready to operate the trowel!
comfortable position where all controls are accessible.
• Visually check to be sure that the blades are free of obstructions and the area is clear
for operation.
• Start the trowel following the instructions in the engine manufacturer's
operation manual. For diesel powered trowels, follow the instructions for
glow plug and cold start operation.
• Observe any gauges and warning lights to ensure they are functioning and their
readings are within the manufacturer's normal operating range.
•
Check operation of controls. Make certain they operate properly.
• You are ready to operate the trowel!!
WORK SAFELY
SAFE WORKING PROCEDURES
DANGER – CARBON MONOXIDE
Exhaust from the engine contains poisonous carbon monoxide gas that is
not easily detected as it is colorless and odorless. Exposure to carbon
monoxide can cause loss of consciousness and may lead to death! Do not
operate your trowel indoors or in an enclosed area unless adequate
•
Do not start or operate the trowel if the drive train will not
disengage. Centrifugal force between the trowel and surface
37