Table of Contents
Advertisement
www.crownequip.com
(204) 831 8468
5.1
Periodic Maintenance Schedule
The chart below lists basic machine and engine maintenance. Refer to the engine
manufacturer's Operator's Manual for additional information on engine maintenance.
Activity
Check fuel level.
Check engine oil level.
Inspect fuel lines.
Inspect air filter. Replace as needed.
Check external hardware.
Clean trowel after each use to
remove concrete splatter
Clean air cleaner elements.
Change engine oil.
Check drive belt.
Clean sediment cup.
Check and clean spark plug.
Check and adjust valve clearances.
● Perform initially after first 20 hours of operation.
Maintenance, replacement or repair of emission control devices and systems may be
performed by any repair establishment or individual.
5.2 Engine Oil
See Graphic 8
5.2.1 Drain oil while the engine is still warm.
5.2.2 Remove the oil fill plug (a) and drain cap (b) to drain oil.
Note: In the interests of environmental protection, place a plastic sheet and a container
under the machine to collect any liquid which drains off. Dispose of this liquid in
accordance with environmental protection legislation.
5.2.3 Install drain cap.
5.2.4 Fill the engine crankcase with recommended oil up to the level of the plug opening
(c). See Technical Data for oil quantity and type.
5.2.5 Install the oil filler plug.
5. Maintenance
Daily
•
•
•
•
•
•
Graphic 8
After first
Every
20 hrs.
50 hrs.
•
•
Every
Every
100 hrs.
300 hrs.
•
•
•
•
•
Advertisement
Table of Contents
