Operation - Crown WBT36 Operator's Safety And Service

www.crownequip.com
(204) 831 8468
WARNING: DO NOT operate the trowel if the engine control module is
disconnected or not functioning properly.

4.12 Operation

See Graphic 6
WARNING: ALWAYS test the function of the engine control module before
operating the trowel. DO NOT operate the trowel if the engine control module is
not functioning properly.
Choose correct blade type and attach blades to trowel arms. Do not mix float or finish blades
with combination blades.
Note: When operating on soft concrete, do not let trowel stand in one spot too long.
Always lift trowel from slab when operation is complete.
Note: "Left" and "Right" references are made from the operator's position.
4.12.1 Adjust handle height to suit operator. See Installing and Adjusting Handles.
CAUTION: Do not attempt to adjust handle height on the trowel while it is
4.12.2 Start engine and engage blades by increasing engine speed. Set speed with throttle
control on handle bar to appropriate speed for job conditions.
4.12.3 To move trowel forward twist handle clockwise (a).
4.12.4 To move backward twist handle counterclockwise (b).
4.12.5 To move to the left lift up slightly on the handle (c).
4.12.6 To move to the right press down slightly on the handle (d).
4.12.7 Clean trowel after each use to remove concrete splatter.
WARNING: Allow the muffler to cool before cleaning or servicing the machine. A
hot muffler could ignite the fuel and start a fire.
It is recommended that each set of work passes be at 90° to the previous set of work passes.
This will help prevent the creation of valleys in the slab surface.
For example, in the illustration, the second set of work passes (2) is 90° to the first set of
work passes (1).
WARNING: Personnel other than the trowel operator should not be allowed in the
work area, as severe injury can occur from contact with operating trowel blades.
Do not attempt to clean, service or perform adjustments on the trowel while it is running.
running.