Cleaning Sediment Cup; Adjusting Idle Speed - Crown WBT36 Operator's Safety And Service

www.crownequip.com
(204) 831 8468
See Graphic 11
5.5.1 Turn the fuel valve off.
5.5.2 Remove the sediment cup (a) and the O-ring (b).
5.5.3 Wash both thoroughly in a nonflammable solvent. Dry and reinstall them.
5.5.4 Turn the fuel valve on and check for leaks.

5.6 Adjusting Idle Speed

See Graphic 12
WARNING: Remove the drive belt before making any adjustment to the
carburetor. See Belt Replacement. The blades will engage unless the belt is
removed from the machine.
Adjust engine to the no load or idle speed per the Technical Data.
5.6.1 Start the engine and allow it to warm up to normal operating temperature.
5.6.2 Turn the throttle stop screw (a) in to increase speed, out to decrease speed. Make
sure the throttle lever is touching the stop screw before measuring rpm.

5.5 Cleaning Sediment Cup

Graphic 11
Graphic 12