Evacuate Button; Viewing Multiple Fire Events - Honeywell NOTIFIER INSPIRE E10 Operating Instructions Manual

Evacuate Button

EVACUATE BUTTON
This touch screen 'Evacuate' button
is not VdS approved. Normally hidden,
this button is configured during
commissioning to appear on the
panel screen to meet site needs where
required, such as in the UK.
01
Log in with your Access level 2 password.
02
Press touch screen 'Evacuate' button (see
the previous page) and acknowledge
the Alarm Sounders in the system.
03
Pressing the 'SILENCE-RESOUND' button will
silence all the Alarm Sounders.

VIEWING MULTIPLE FIRE EVENTS

If the panel enters the alarm state with more than one
zone in a Fire condition then these visual and audible
indications are given:
The display shows information about fire events, such

as the first zone and latest zone
Also:
- The general FIRE LED (red)

- Zones in Fire are indicated on the display
- and the First Zone in fire is a flashing indication.

- The panel buzzer operates and you can mute the
sound by pressing the 'MUTE BUZZER' button
18

on
to start all

in fire condition.

is lit

.
Any outputs are programmed to operate immediately
including sounder devices are automatically activated.

Select Show All button to view details of all active
Zone fire events.
Log Book Entry
Enter information about this fire event(s) in the log
book. Ensure the log entry contains the date of the
event(s) and also the keyholder's name / signature.
Information about the alarm event is also stored in the
fire control panel's event log and can be accessed by
the service engineer.
FIRE

Accident and Emergency Ground Floor - West wing
Accident and Emergency Ground Floor - East wing

VdS






MUTE BUZZER