Led Indicators And Push Button Controls - Honeywell NOTIFIER INSPIRE E10 Operating Instructions Manual

LED INDICATORS AND PUSH BUTTON CONTROLS

There are 7 status LED indicators provided on the panel fascia and there are 3 push buttons for event conditions.
Condition / LED
Control Colour
FIRE Red
FAULT Yellow
SYSTEM FAULT Yellow
DISABLE Yellow
TEST Yellow
DELAY ACTIVE Yellow
POWER Green
The essential controls are the push buttons and touch screen buttons, when lit
they are active for selection by the authorised users having password access to the
controls The buttons are made active during event conditions, such as after fire
detection or when a fault has occurred in the system.
SILENCE/ White
RESOUND
MUTE BUZZER White
RESET White
INSPIRE E10/E15 Control Panels - Operating instructions
Description
A fire condition has been detected.
There is a fault in the system.
The system software or parts of it has failed
and/or the site specific data is corrupt.
One or more device / zone are disabled.
A system test is in progress.
One or more sounder / output delay is
configured in the Cause & Effect matrix.
The system is switched On and the power is
supplied via the mains voltage.
Silence or Resound the alarms sounders and
outputs in the system.
Silence the panel buzzer.
Reset the panel after a fire condition.
FIRE
FAULT FAULT
SYSTEM FAULT
DISABLE
TEST
DELAY ACTIVE
POWER
SILENCE-RESOUND
MUTE BUZZER
RESET
5