Fire Condition; What Do I Need To Do - Honeywell NOTIFIER INSPIRE E10 Operating Instructions Manual

FIRE CONDITION

When one or more fire events occur, the screen turns red, the
first zone in alarm and the time the zone went into the fire

condition is displayed

first Zone in Fire . Also, the total number of active zones in

fire is shown . For fire events, the information on the display
is supported by lit general FIRE LED
The panel buzzer provides an audible sound
BUZZER key is lit to prompt an action.

WHAT DO I NEED TO DO?

Use the information provided by the Display and the LEDs to
understand quickly the situation and what action needs to
be taken. To assist this process, the panel's display indicates
the zone location(s) of the fire event(s). Use the information
provided to identify the geographic source of the fire. Follow
site procedures on what to do in the event of a fire.
01
To silence panel buzzer select MUTE BUZZER
Touch Screen or press the push button on the panel.
02
Log in with your Access level 2 password.
03
If configured, the Alarms delay will be activated
and will be replaced by the Verification Delay
Verification delay button is
ACTIVE LED will be lit and the count-down time will now
show the Verification delay. The Delay can be forced to
end by selecting the End Delay
04
With the emergency over and when it is safe to do so
. A flashing indication is given of the

.

and the MUTE
pressed. Note the DELAY

button.
INSPIRE E10/E15 Control Panels - Operating instructions
select SILENCE-RESOUND button to
silence Alarms
05
When the devices responsible for the
alarm is cleared for normal operation
then select RESET
push button on the panel.

FIRE
Accident and Emergency Ground Floor - West
on the


if the
SILENCE-RESOUND
.

touch screen or






Veri cation delay

DELAY ACTIVE
MUTE BUZZER RESET



VdS
17