Quantum LTO 4 Quick Start Manual page 4

LTO-4 Half-Height Tape Drive Quick Start Guide
Figure 2 Acceptable Mounting
Orientations
4
YES
Mount the internal drive in a 5.25-inch, half-height drive bay as follows:
1 As required:
a Save and close your open files and terminate all running applications.
b Shut down the workstation or server system.
c Disconnect the system AC power cord from the facility AC power receptacle.
2 Remove the cover from the workstation or server system.
See your computer manufacturer's instructions for the proper procedures
Note:
to remove the cover.
Select an available 5.25-inch half-height bay and, if required, remove the bay cover.
3
Position the drive in the bay and align either the upper or lower mounting holes—
4
whichever is appropriate—with the holes in the chassis (see
5 Secure the drive using two M3.0 X 5 metric screws on each side
Using screws longer than 5 mm can damage the drive.
Caution:
Do not use screws longer than 5 mm to secure the internal LTO-4 Half-
Height Tape Drive.
After mounting the internal LTO-4 Half-Height Tape Drive, proceed to
Internal Drive Interface and DC Power Cables
Installing the Internal LTO-4 Half-Height Tape Drive
YES YES
in the following subsection.
NO
figure 3).
Connecting the