Quantum LTO 4 Quick Start Manual page 2

LTO-4 Half-Height Tape Drive Quick Start Guide
Before Installing the LTO-4 Half-Height Tape Drive
Handling Precautions and
Installation Guidelines
Preinstallation
Requirements
2
Always observe the following precautions and guidelines when handling and installing
0
LTO-4 Half-Height Tape Drives:
• Internal, at all times
• Tabletop, when removed from its free-standing enclosure
Handling Precautions
Installation Guidelines
Before installing the LTO-4 Half-Height Tape Drive, make sure you have:
0
• A serial SCSI host bus adapter (HBA) installed and properly configured in the host
computer
• Interface components, either:
• 7-pin 1x SATA-style interface cable for an internal drive
• 26-pin SFF-8088 mini-SAS style interface cable for a tabletop drive
Before Installing the LTO-4 Half-Height Tape Drive
• Internal drives have exposed components that are
sensitive to static electricity. To reduce the possibility of
damage from static discharge, the drives are packaged
in a protective antistatic bag. Do not remove the drive
from the antistatic bag until you are ready to install it.
• Wear an ESD-preventive grounding wrist strap or
observe similar ESD precautions when working with the
drive. Be sure the wrist strap makes good skin contact.
Do not remove the wrist strap until you finish working
with the drive.
Also, avoid contact between the drive, other equipment,
and clothing. The wrist strap only protects the
equipment from ESD voltages on the body; ESD
voltages on clothing can still cause damage.
• Before removing the drive from the antistatic bag, touch
a grounded metal surface to discharge any static
electricity buildup from your body.
• Handle the drive by its sides rather than by the top
cover to reduce the risk of dropping the drive or
damaging it during installation.
• Either lay the drive on a nonconductive surface or put it
back inside the protective antistatic bag to reduce the
chance of damage from static discharge
• Due to the high speed of the LTO-4 Half-Height Tape
Drive, do not connect more than one LTO-4 drive to the
same host bus adapter (HBA).