Blaupunkt LS180 Owner's Manual page 7

Remote control battery installation
Open up the battery door and insert 2 x AAA dry battery(included) into the compartment; please make sure the polarity of
battery will aim and correspond to the positive and negative silkscreen-printed symbol in the compartment. Then close the
battery door.
Notes:
a. The best working distance of remote control is within 5 meters without any obstacle in between. Please aim to the
remote control sensor locates on the front of unit during operation.
b. The sensitivity of remote control will become weak when the battery power exhausted. Please replace it with fresh one
for operation.
c. Please take out the battery in case of none-operation in a long time.
d. Please dispose the battery in an environment friendly way. Please reference the local government requirement for the
detail.
Soundbar placement
You can choose to place the soundbar on a flat surface or wall-mounting way as following.
1. Place on a flat surface: Place the unit horizontally on a flat surface such as a TV unit or shelves and align it centrally with
the TV screen. Allow some space between the speaker and the wall. Do not place it inside a cabinet or a walled shelf. Follow
this guidance for best sound output and good airflow around the soundbar.
2. Mount on the wall
a. Take out the double-sided glue tape from the package and tear off the one side protective layer; then paste it onto the
supplied L shaped wall-mounting bracket according to the suitable poistion where the soundbar desire for placement(
avoidance the bottom rubber foot place). Please reference below photo a and b.
b. Choose proper distance and attach the wall-mounting bracket onto the soundbar( avoidance bottom rubber foot), then
take the soundbar for location on the wall(like below photo c); choose the proper distance mark 4 holes by a pencil on the
wall. Then drill the mounting holes directly.
c. Fix the supplied plastic anchors into the drilled hole, lock the wall-mounting bracket on the wall by supplied screws, and
tighten it. Please reference below photo d, e and f.
d. After fastening the screws, tear off another side protective layer of tape from locked bracket, replace the soundbar on it
for fitting and matching, press it firmly and finish the wall-mounting.
Important notes
a. Please make sure there will avoid the bottom rubber foot of soundbar during choose location and mounting, because
there cause uneven and unstable issue when we place the sound bar on the wall-mounted bracket.
5