Husqvarna AUTOMOWER 550H Operator's Manual page 25

of the obstacle. The product knows that it is close to
the charging station and tries to dock, but the objects
min , avg (average) or max .
prevents it. The options are
Note:
The recommended setting is
better to move the charging station, than to decrease the
range of the charging station signal.
Settings > Installation > Find charging
1. Select
station in the app.
2. Select signal range.
Save .
3. Select
To set the delay time for the guide wire and the
boundary wire
1. Select Settings > Installation > Find charging
station in the app.
on/off to enable or disable to follow the wire.
2. Select
3. Move the horizontal bar to set the time delay.
4. Select Save .
3.11.4.2 Lawn coverage
The product has GPS Assisted Navigation that helps the
product select the most optimal operation.
Lawn coverage function to set the settings to
Use the
manual.
To set the GPS function
1. Select Installation > Settings > Lawn coverage in
the app.
on/off to disable or enable the GPS
2. Select
function.
Note:
When GPS assisted navigation is enabled
it is used while there is a GPS service. The GPS
assisted navigation is used even if manual settings
have been made. Only when GPS service is not
available, the manual settings are used.
3. Select Save .
To set the Lawn Coverage function
The Lawn Coverage function is used to guide the
product to remote parts of the work area. If the work
area includes remote parts that are connected with
Lawn Coverage function is useful
narrow passages, the
to to keep a well-cut lawn in all parts of the yard. You
can set a maximum of 5 remote areas where the product
starts to cut the lawn.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a certain
distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
1457 - 012 - 19.01.2023
max . It is usually
Each area can be enabled or disabled, without having to
enter the settings again.
1. Select
the app.
2. Select
Lawn Coverage .
3. Select on/off
4. Move the horizontal bar to set which wire
the product will follow. The product can follow
Boundary wire left , Boundary wire right or one of
the guide wires.
5. Move the horizontal bar to set the distance the
product must follow the wire. The product then
leaves the wire and starts to cut the lawn. Refer to
To measure the distance from the charging station
on page 25 .
6. Move the horizontal bar to set how often the
product goes to each area. At all other times, the
products starts to cut near the charging station.
The percentage is equal to the percentage of the
area in relation to the complete work area.
a)
b)
c)
d)
7. Select
The default settings lets the product follow the guide
wire 300 m / 980 ft. in 20% of the times it leaves the
charging station. If the guide wire is less than 300 m /
980 ft. the product will follow it to the point where the
guide wire is connected to the boundary wire.
To measure the distance from the charging station
1. Put the product in the charging station.
2. Select
the app.
A
Settings > Installation > Lawn coverage in
on/off to disable the GPS function to set the
Area 1-5 to activate the area.
Measure the area.
Divide the measured area with the total work
area.
Convert the result to percentage.
Move the horizontal bar to set the distance
from the charging station.
Save .
Settings > Installation > Lawn coverage in
C
B
Installation - 25