Husqvarna AUTOMOWER 550H Operator's Manual page 38

Message Cause
Charging station
The contact between the charging plates and
blocked
contact plates may be poor and the product
has made a number of attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
Stuck in charging sta-
The product slips on the baseplate.
tion
There is an object in the way of the product
preventing it from leaving the charging sta-
tion.
Upside down
The product is leaning too much or has
turned over.
Mower tilted
The product is tilted more than the maximum
angle.
Needs manual charg- The product is set to the
ing
erating mode.
Next start hh:mm
The schedule setting prevents the product
from operating.
The clock on the product is not correct.
Lifted
The lift sensor is engaged because the prod-
uct hit an object or/and is blocked.
Collision sensor The body of the product can not move freely
problem, front/rear
around its chassis.
The product has become stuck.
Wheel motor blocked
Grass or other object is wrapped around the
right/left
drive wheel.
Alarm! Mower switch-
The alarm was activated because the prod-
ed off
uct was switched OFF.
Alarm! Mower stop-
The alarm was activated because the prod-
ped uct was stopped.
Alarm! Mower lifted
The alarm was activated because the prod-
uct was lifted.
Alarm! Mower tilted The alarm was activated because the prod-
uct was tilted.
38 - Troubleshooting
Action
Put the product in the charging station and
check that the charging plates and contact
plates make good contact.
Remove the object.
Confirm that the charging station is placed on
a fully flat and horizontal ground. The charg-
ing station must not be tilted or bent.
Clean the baseplate.
Remove the object.
Turn the product the right way up.
Move the product to a flat area.
Secondary area op- Place the product in the charging station.
This behavior is normal and no action is re-
quired.
Change the schedule settings. Refer to
Schedule on page 22 .
Set the time. Refer to
27 .
Free the product. If the problem stays, speak
to your approved servicing dealer.
Remove dirt or objects between the chassis
and the body to make sure that the body can
move freely around the chassis.
Free the product and rectify the reason.
Clean the wheels and around the wheels.
Adjust the mower security settings in the
curity menu. Refer to Security (Bluetooth
only) on page 27 .
Time & date on page
Se-
®
1457 - 012 - 19.01.2023