GAS GAS MC 250F 2022 Owner's Manual page 112

17 SERVICE WORK ON THE ENGINE
110
–
Remove screw plug
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
G05104-10
–
Position oil screen
–
Position the pin wrench through the drill hole of the screw plug in
the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
G05105-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
seal ring.
Guideline
Oil drain plug with
magnet
E01243-10
–
Remove screws
G05091-10
–
6
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
G05092-10
3 4
with oil screen and the O-rings.
4
with the O-rings on a pin wrench.
3
with the O-ring.
M20x1.5 15 Nm (11.1 lbf ft)
1
with the magnet and a new
M12x1.5 20 Nm (14.8 lbf ft)
5
. Remove the oil filter cover with the O-ring.
out of the oil filter housing.