Table of Contents
Advertisement
Table 5-2
Computer Setup—Security (continued)
Option
System Management
Command
Restore Security
Settings to Default
Computer Setup—Advanced
NOTE:
Support for specific Computer Setup options may vary depending on the hardware configuration.
Table 5-3
Computer Setup—Advanced (for advanced users)
Option
Display Language
Scheduled Power-On
Boot Options
76
Chapter 5 Computer Setup (F10) Utility
Description
successfully entered, the hard drive will remain inaccessible until one of the passwords is
successfully provided during a subsequent cold-boot sequence.
NOTE:
This selection will only appear when at least one drive that supports the DriveLock feature
is attached to the system.
CAUTION:
Be aware that these settings take place immediately. A save is not necessary.
CAUTION:
Be sure to document the DriveLock password. Losing a DriveLock password will render a
drive permanently locked.
After you select a drive, the following options are available:
Set DriveLock Master Password. Sets the drive's master password but does not enable DriveLock.
Enable DriveLock. Sets the drive's user password and enables DriveLock.
Secure Erase
●
Lets you select a hard drive to completely erase.
Once a hard drive has been erased with a program that utilizes Secure Erase firmware commands, no
file recovery program, partition recovery program, or other data recovery method will be able to
extract data from the drive.
Allow OPAL Hard Drive SID Authentication
●
Allows authorized personnel to reset security settings during a service event. Default is enabled.
This action resets security devices, clears BIOS passwords (not including DriveLock), and restores settings
in the Security menu to factory defaults.
Heading
Lets you select the language of the menus in F10 Setup and the keyboard layout.
This feature wakes the system up from a powered off state at a specified date and time.
Select the devices that the computer can boot from, as well as other options, including:
Startup Menu Delay(sec). Enabling this feature will add a user-specified delay to the POST process.
●
One purpose for the delay is to provide additional time to activate hotkeys such as
Startup Menu or
F10
for Computer Setup.
●
Fast Boot. Default is enabled.
●
CD-ROM Boot. Default is enabled.
USB Storage Boot. Default is enabled.
●
●
Network (PXE) Boot. Default is enabled.
●
After Power Loss. Default is Power Off.
■
Power off—causes the computer to remain powered off when power is restored.
■
Power on—causes the computer to power on automatically as soon as power is restored.
Esc
for the
Hide quick links:
Advertisement
Table of Contents
