Speaker - HP EliteDesk 880 G4 TWR Maintenance And Service Manual

Speaker

The speaker is attached to the front of the chassis. Remove it from the inside of the chassis.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Rotate the drive cage up (see
6. Disconnect the speaker cable from the system board connector labeled SPKR (1).
7. Remove the speaker cable from the clip on the bottom of the chassis (2).
8. Remove the Torx T15 screw (3) that secures the speaker to the chassis.
9. Remove the speaker from the chassis (4).
To replace the speaker, reverse the removal procedures.
62 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page 19).
(Front bezel on page 20).
Drive cage on page 28)
18).