Figure 25. Removing hard drive backplane
Installing hard drive backplane
Steps
1. Use the hooks on the system as guides to align the hard drive backplane.
2. Lower the hard drive backplane until the release tabs snap into place. If applicable, tighten the captive screws on the
backplane.
Next steps
1. Connect all the cables to the backplane.
2. Install all the hard drives.
3. Install the backplane cover.
4. Install the cooling fan assembly.
5. Install the air shroud.
Front USB module
Removing front USB module
Prerequisites
1. Remove the front bezel.
2. Remove the system cover.
Steps
1. Unroute the cable and remove the screw that secures the USB module on the system.
2. Push the cable and disconnect it from the system.
3. Remove the front USB module from the system.
66
Disassembly and reassembly