Table of Contents
Advertisement
Installing vFlash card
Steps
1. Locate the vFlash connector on the system board. To locate vFlash connector, see
section.
2. Align the vFlash expansion card with the connector on the system board and push until it is firmly seated on the system
board.
3. Insert the vFlash card into the slot on the vFLash expansion card.
Next steps
1. If applicable, install the full height PCIe card in expansion card riser 2.
Network daughter card
Removing network daughter card
Prerequisites
1. Remove the expansion card riser 2.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the Network Daughter Card (NDC) to the system
board.
2. Hold the NDC by the edges on either side of the touch points and lift to remove it from the connector on the system board.
3. Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
64
Disassembly and reassembly
System board jumpers and connectors
Advertisement
Table of Contents
