Table of Contents
Advertisement
Next steps
1. If removed, install expansion cards into the riser and connect any cable disconnected.
2. If applicable, install the air shroud.
NOTE:
If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card riser 3
Prerequisites
1. If applicable, remove the air shroud.
NOTE:
If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
2. If installed, remove expansion cards installed on the riser.
3. Disconnect any cables connected to the riser card.
Steps
1. Using Phillips #2 screwdriver, loosen the screw that secures the riser to the system.
2. Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
Figure 24. Removing expansion card riser 3
Installing expansion card riser 3
Steps
1. Align the following:
a. Tab on the riser with the slot on the system and guide rails on the riser with the standoffs on the side of the system.
b. Lower the riser into the system until the riser edge connector engages with the connector on the system board.
The riser card edge engages with the riser guide on the system.
2. Using Phillips #2 screwdriver, tighten the screw to secure the riser to the system.
Disassembly and reassembly
61
Advertisement
Table of Contents
