Table of Contents
Advertisement
Steps
1. Align the guide rails on the riser with the standoffs on the side of the system.
2. Lower the riser into the system until the riser card connector engages with the connector on the system board.
Next steps
1. If removed, install expansion cards into the riser.
2. Connect the cable which disconnected from the expansion card.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card riser 2
Prerequisites
1. If applicable, remove the air shroud.
NOTE:
If applicable, close the PCIe card holder latch on the air shroud to release the full length card.
2. If installed, remove expansion cards installed on the riser.
3. Disconnect any cables connected to the riser card.
Steps
1. To remove expansion card riser 2A:
a. Using Phillips #2 screwdriver, loosen the screws that secure the riser to the system.
b. Press the release tab, and holding the riser by its edges, lift the riser from the riser connector on the system board.
Figure 23. Removing expansion card riser 2A
2. Remove the expansion card riser.
Installing expansion card riser 2
Steps
To install expansion card riser 2A:
a. Align the screw and tab on the riser with the screw hole and slot on the system.
b. Lower the riser into the system until the riser connector engages with the connector on the system board.
c. Using Phillips #2 screwdriver, tighten the screws to secure the riser to the system.
60
Disassembly and reassembly
Advertisement
Table of Contents
