Front Usb Module - Dell Precision 7920 Rack Owner's Manual

Figure 23. Removing hard drive backplane
Installing hard drive backplane
Steps
1 Use the hooks on the system as guides to align the hard drive backplane.
2 Lower the hard drive backplane until the release tabs snap into place. If applicable, tighten the captive screws on the backplane.
Next steps
1 Connect all the cables to the backplane.
2 Install all the hard drives.
3 Install the backplane cover.
4 Install the cooling fan assembly.
5 Install the air shroud.

Front USB module

Removing front USB module
Prerequisites
1 Remove the front bezel.
2 Remove the system cover.
Steps
1 Unroute the cable and remove the screw that secures the USB module on the system.
2 Push the cable and disconnect it from the system.
3 Remove the front USB module from the system.
60 Removing and installing components