Network Daughter Card - Dell Precision 7920 Rack Owner's Manual

NOTE: Temporarily label each micro SD card with its corresponding slot number after removal
Steps
1 Locate the vFlash connector on the system board. To locate vFlash , see the System board jumpers and connectors section.
2 Holding the pull tab, lift the vFlash card out of the system.
Installing vFlash card
Steps
1 Locate the vFlash connector on the system board. To locate vFlash, see the System board jumpers and connectors section.
2 Align vFlash card with the connector on the system board.
3 Push vFlash card until it is firmly seated on the system board.
Next step
1 If applicable, install the full height PCIe card in expansion card riser 2.

Network daughter card

Removing network daughter card
Prerequisite
1 Remove the expansion card riser 2.
Steps
1 Using a Phillips #2 screwdriver, loosen the captive screws that secure the Network Daughter Card (NDC) to the system board.
2 Hold the NDC by the edges on either side of the touch points and lift to remove it from the connector on the system board.
3 Slide the NDC away from the back of the system until the Ethernet connectors are clear of the slot in the back panel.
58 Removing and installing components