Power-Adapter Port; Removing The Power-Adapter Port - Dell Vostro 3520 Service Manual

Steps
1. Place the system board on the palm-rest and keyboard assembly.
2. Align the screw holes on the system board with the screw holes on the palm-rest assembly.
3. Replace the single (M2x2) screw that secures the system board to the palm-rest assembly.
4. Replace the three (M2x3.5) screws that secure the system board to the palm-rest assembly.
5. Connect the following cables to the system board:
a. I/O board Flexible Flat cable
b. Speaker cable
c. Hard drive Flexible Flat cable (for systems with 2.5-inch hard drive)
d. Touchpad Flexible Flat cable
e. Keyboard backlight Flexible Printed cable (for systems with backlit keyboard)
f. Keyboard Flexible Printed cable
g. Power adapter port cable
h. eDP cable
6. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
7. Replace the two (M2.5x5) screws to secure it to the palm-rest assembly.
Next steps
1. Install the display assembly.
2. Install the heat sink.
3. Install the fan.
4. Install the wireless card.
5. Install the memory modules.
6. Install the M.2 2230 solid-state drive
7. Install the 3-cell battery
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in

Power-adapter port

Removing the power-adapter port

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the display assembly.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
or M.2 2280 solid-state drive
or 4-cell battery (whichever applicable).
After working inside your
Before working inside your
(whichever applicable).
computer.
computer.
Removing and installing components 99