Table of Contents
Advertisement
Steps
1. Using the alignment post, place the power-adapter port into its slot on the palm-rest and keyboard assembly.
2. Connect the power-adapter port cable to the connector on the system board.
3. Fold the right hinge down and install the two (M2.5x5) screws to secure it to the palm-rest and keyboard assembly.
Next steps
1. Install the
display
assembly.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the
3-cell battery
5. Remove the
M.2 2230 solid-state drive
6. Remove the
memory
modules.
7. Remove the
wireless
card.
After working inside your
Before working inside your
or
4-cell battery
(whichever applicable).
or
M.2 2280 solid-state drive
computer.
computer.
(whichever applicable).
Removing and installing components
101
Advertisement
Table of Contents
