IBM 5886 Removal And Replacement Procedures page 19

3. Remove both power supplies and disk drives.
a. Remove all the disk drives, following the "Disk unit" on page 3 removal procedures.
b. Make sure that the power switch (A) on the right side of the power supply that is to be removed
is in the off position.
c. Label and remove the power cable from the power supply to be removed.
d. On the left side of the power supply, press the orange release tab (B) to the right as you rotate the
handle (C) downward.
e. Using the handle, gently slide the power supply out of the enclosure, make sure that you support
the bottom while you do this.
f. Repeat these steps until both power supplies have been removed from the failing unit.
Removal and replacement procedures
7