Panasonic PT-TW230EA Operating Instructions Manual page 63

Replacing the Lamp unit
J
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
1 ) Turn off the Power by following the procedure
in "Turning Off the projector" (
Unplug the AC power cord. Wait at least 1 hour
and make sure the lamp unit and
surroundings are cool.
2 ) Use a Phillips screwdriver to loosen the
lamp cover fixing screw and remove the l
amp cover.
Remove the lamp cover by pulling it slowly
z
toward the direction of the arrow.
3 ) Use a Phillips screwdriver to loosen the
three lamp unit fixing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently
from the projector.
4 ) Insert the new lamp unit in correct
direction. Tighten the three lamp unit
fixing screws securely with a Phillips
screwdriver
5 ) Attach the lamp cover, and tighten the
lamp cover fixing screw securely with
a Phillips screwdriver.
Attach the lamp cover by pushing it slowly
z
opposite the direction of the arrow.
Resetting the Lamp Runtime
J
Be sure to reset the [Lamp runtime] after replacing the lamp. (
z
page 29).
Æ
Æ page 56 " Lamp runtime reset")
Replacement
Lamp cover
Lamp cover
fixing screw
Lamp cover fixing screw
Handles
Lamp unit
63
ENGLISH -