Toyota RAV4 HYBRID 2020 Manual page 558

558
6-4. Using the other interior features
®
 HomeLink
minates: Programming of a
fixed code device has com-
pleted. The garage door or
other device should operate
when a HomeLink
pressed and released.
®
 HomeLink
flashes rapidly: The garage
door opener or other device is
equipped with a rolling code.
To complete programming,
firmly press and hold the
®
HomeLink
onds then release it.
 If the garage door or other
device does not operate, pro-
ceed to "Programming a roll-
ing code system".
5
Repeat the steps above to
program another device for
any of the remaining
®
HomeLink
Programming a rolling code
■
system
Two or more people may be
needed to complete rolling code
programming.
1
Locate the "Learn" or "Smart"
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by
manufacturer. Refer to the owner's
manual supplied with the garage
indicator light illu-
®
button is
indicator light
button for 2 sec-
buttons.
door opener motor for details.
2
Press and release the
"Learn" or "Smart" button.
3
Perform within 30 seconds after
performing 2.
3
Press and hold the desired
®
HomeLink button (inside the
vehicle) for 2 seconds and
release it. Repeat this
sequence
(press/hold/release) up to 3
times to complete program-
ming.
If the garage door opener
motor operates when the
®
HomeLink button is
pressed, the garage door
opener motor recognizes the
®
HomeLink signal.