Toyota RAV4 HYBRID 2020 Manual page 213

Hide thumbs Also See for RAV4 HYBRID 2020:
Table of Contents

Advertisement

from any power switch mode.
5
Check that the "READY" indi-
cator is illuminated.
The vehicle will not move when the
"READY" indicator is off.
If the hybrid system does not
start
The immobilizer system may not
have been deactivated. (P.81)
Contact your Toyota dealer.
If a message related to start-up is
shown on the multi-information
display, read the message and fol-
low the instructions.
When the ambient temperature
is low, such as during winter
driving conditions
When starting the hybrid system,
the flashing time of the "READY"
indicator may be long. Leave the
vehicle as it is until the "READY"
indicator is steady on, as steady
means the vehicle is able to move.
When the hybrid battery (traction
battery) is extremely cold (below
approximately -22°F [-30°C])
under the influence of the outside
temperature, it may not be possi-
ble to start the hybrid system. In
this case, try to start the hybrid
system again after the tempera-
ture of the hybrid battery
increases due to the outside tem-
perature increase etc.
Sounds and vibrations specific
to a hybrid vehicle
P.74
4-2. Driving procedures
If the 12-volt battery is dis-
charged
The hybrid system cannot be
started using the smart key system.
Refer to P.666 to restart the hybrid
system.
Electronic key battery depletion
P.122
Conditions affecting operation
P.149
Note for the entry function
P.150
Steering lock function
After turning the power switch to
OFF and opening and closing the
doors, the steering wheel will be
locked due to the steering lock
function. Operating the power
switch again automatically can-
cels the steering lock.
When the steering lock cannot be
released, "Push power switch
while turning the steering wheel in
either direction" will be displayed
on the multi-information display.
Check that the shift lever is set in
P. Press the power switch shortly
and firmly while turning the steer-
ing wheel left and right.
To prevent the steering lock motor
from overheating, the motor may
be suspended if the hybrid system
is turned on and off repeatedly in
a short period of time. In this case,
refrain from operating the power
switch. After about 10 seconds,
the steering lock motor will
resume functioning.
213
4

Advertisement

Table of Contents
loading

Table of Contents