Toyota RAV4 HYBRID 2020 Manual page 101

Power area
E
Shows that an Eco-friendly driving
range is being exceeded (during full
power driving etc.)
*
: When used in this manual, "regen-
eration" refers to the conversion of
energy created by the movement
of the vehicle into electrical
energy.
In the following situation, the Hybrid
System Indicator does not operate.
● "READY" indicator is not illumi-
nated.
● The shift lever is in a range other
than D or S.
■ Outside temperature display
● In the following situations, the cor-
rect outside temperature may not
be displayed, or the display may
take longer than normal to
change.
• When stopped, or driving at low
speeds (less than 12 mph [20
km/h])
• When the outside temperature
has changed suddenly (at the
entrance/exit of a garage, tunnel,
etc.)
● When "--" or "E" is displayed, the
system may be malfunctioning.
Take your vehicle to your Toyota
dealer.
● Displays the outside temperature
within the range of -40°F (-40°C)
to 122°F (50°C).
● When the outside temperature is
approximately 37°F (3°C) or
lower, the indicator
for approximately 10 seconds,
then stay on.
■ Liquid crystal display
P.104
■ Customization
Settings (e. g. meter display) can be
changed on the
multi-information display. (P.108)
■ The information display at
low temperatures
Allow the interior of the vehicle to
warm up before using the liquid
crystal information display. At
extremely low temperatures, the
display monitor may respond
slowly, and display changes may
be delayed.
For example, there is a lag
between the driver's shifting and
the new shift range appearing on
the display. This lag could cause
the driver to downshift again,
causing rapid and excessive
engine braking and possibly an
accident resulting in death or
injury.
■ To prevent damage to the
engine and its components
The engine may be overheating if
the engine coolant temperature
gauge is in the red zone ("H"). In
this case, immediately stop the
vehicle in a safe place, and check
the engine after it has cooled
completely. (P.671)
Using the "ODO TRIP"
switch
Switches the items of the odom-
will flash
eter, trip meter A and trip meter
B by pressing the "ODO TRIP"
switch.
When the trip meter is dis-
played, pressing and holding the
switch will reset the trip meter.
2-1. Instrument cluster
WARNING
NOTICE
101
screen of the
2