QSC RAVE 520az Hardware Manual page 19

Getting Started (continued)
17- Select Device, Add New Device, from the menu. A new window will open prompting you to name the device. Name it logically,
such as RAVE 1, or similar. Select the Device Type and select RAVE 520az. At the Password prompt, enter "qsc" (lower case, no quota-
tion marks). This is the device password, separate from the software password. The default, in both cases, is "qsc", but you are free to
change either or both. Enter the IP address of the RAVE and click OK.
18- The RAVE will now appear in the inventory root (left side of screen). If the RAVE does not show in the inventory root, check that a
crossover cable is used (only for RAVE connected directly to PC), check the cable connections, verify IP addresses are set correctly, ver-
ify Subnet masks are set correctly, and verify AC power is properly applied to the RAVE.
19- Click on the RAVE 520az in the inventory root. A view of applicable device tabs will open. Click the DSP tab and the current DSP
configuration of the RAVE will be displayed.
20- Right click on the Design Editor icon in the lower left of your display; select "New". A new window opens; select RAVE 520az for
the device type.
21- Click on Help to access the software's Help system. All software operation is covered in the on-line help file.
Operation of the RAVE 520az is accomplished with the included QSControl.net software. No software
operation is covered in this hardware manual. After installing your software, open the Help file and
follow its recommendations. The software Help file includes the most recent information available
for your RAVE 520az.
19