Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hyundai power products HPVD16V
Summary of Contents for Hyundai power products HPVD16V
- Page 1 CORDLESS DRILL HPVD16V ORIGINAL INSTRUCTIONS INSTRUCTION...
- Page 2 Fig. A...
-
Page 3: Description (Fig A)
1. APPLICATION The power tool is intended for driving and drilling through wood and plastics It is not designed for professional use. WARNING! Read this manual and general safety instructions carefully before using the appliance, for your own safety. Your power tool should only be passed on together with these instructions. -
Page 4: General Power Tool Safety Warnings
4. SYMBOLS In this manual and/or on the machine the following symbols are used: Denotes risk of personal injury or In accordance with essential damage to the tool. requirements of the European directive(s) Wear eye protection Wear gloves Read manual before use 5. - Page 5 d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.
-
Page 6: Additional Safety Warnings
g) Follow all charging instructions and do not charge the battery pack or tool outside the temperature range specified in the instructions. Charging improperly or at temperatures outside the specified range may damage the battery and increase the risk of fire. 6) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. - Page 7 7.1 Special safety instructions for battery and charger If under extreme conditions any electrolyte should escape from the battery, it's essential to avoid contact with skin. If electrolyte does come into contact with your skin, rinse it off with water. In the event of electrolyte contact with your eyes, it's essential to consult a doctor.
-
Page 8: Residual Risks
not throw unusable storage-battery packet away into the domestic waste, into fire or into water. If the supply cord of the charger is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Use only storage-battery packet, which have been produced by the original manufacturer. -
Page 9: Operation
8. OPERATION 8.1 Charging the battery The battery (5) must be charged before first use. Only after several charge and discharge cycles the battery will attain full capacity. Only use the provided adaptor (10) to charge the battery set. Only charge the battery set when the ambient temperature is within 10° - 40 °C. Plug the adaptor (10) to a 230 V alternating voltage source. -
Page 10: Cleaning And Maintenance
If the dirt does not come off use a soft cloth moistened with soapy water. Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may damage the plastic parts. 10. TECHNICAL DATA Model nr. HPVD16V Rated voltage 16Vd.c. No – load speed 0-650min ¹... -
Page 11: Battery Pack
need to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). -
Page 12: Declaration Of Conformity
ZI, 32 rue Aristide Bergès – 31270 Cugnaux – France Declares that the machinery designated below: Drill / Screwdriver HPVD16V S/N: 20200147627-20200150626 / 20200150627-20200151634 is in conformity with the essential requirements and other relevant provisions of the applicable European Directives, based on the application of European harmonized standards.
Need help?
Do you have a question about the HPVD16V and is the answer not in the manual?
Questions and answers