Waterproofing Your Installation - D-Link Vigilance DCS-4714E User Manual

Section 2: Installation

Waterproofing Your Installation

To waterproof your camera, follow the instructions below. A round Ethernet cable, a crimping tool, and RJ-45 plugs are required for this procedure.
Step 1
Place the washer around the base of the Ethernet connector as shown.
Step 2
Thread the bare Ethernet cable through the waterproof connector as shown, then crimp an
RJ-45 plug onto the cable.
D-Link Vigilance H.265 Outdoor Bullet Camera User Manual 11