Connecting The Charging Unit - Mitel 612 Quick Reference Manual

Mitel 612, 622, 632 and 650 DECT Phones Quick Reference Guide

Connecting the charging unit

Mitel 612, 622, 650: This handset can be used without
any changes to the charger cradle.
Mitel 632: To use this handset, you must remove the two
lateral guides in the charger cradle. They are easy to lift
on the inside edge using a fingernail or a paper clip.
The plastic guides can also be removed, by pushing a
suitable screwdriver into the slits on the bottom of the
charger.
Connect the plug-in power supply to the charger cradle
and place the connection cable through the cable guide.
Place the charger cradle on a non-slip surface. Change
the plug of the power supply unit if necessary.
16
Power Supply / Power unit
The power supply unit is designed for 100V to 240V AC
(50-60 Hz). It is supplied with four change adapters
enabling virtually worldwide use. Where necessary,
connect the plug normally used in your country to the
power supply unit. There are two versions of the plug-in
power supply unit that are connected slightly differently:
Version 1: Press the pushbutton switch on the power
supply unit and push out the existing plug upwards.
Insert the new plug from above into the power supply
unit
Version 2: Remove any existing plug by pressing OPEN.
Then insert the required new plug into the power
supply unit at a slight angle with the label TOP upwards.
Press downwards until it snaps into place
Accessories
The following accessories are available:
Mitel 600 charger with international AC-Adapter
Mitel 612 Handset
Mitel 622 Handset
Mitel 632 Handset
Mitel 650 Handset
Mitel 612, 622, 632, 650/ Rotary-Belt Clip
Mitel 612, 622, 632, 650/ Leather Pouch
Neck Band, including band holder for Mitel 632
Mitel 622, 632, 650/MicroSD-card
Mitel 600 charger Rack with 8 charger cradles
Mitel 612d, 622d, 632d and 650c