ILVE UP76 User Instructions, Installation, Maintenance page 19

9. AU T OM AT I C FU N CT IO N WI TH C OOKIN G TI M E AND E ND OF CO OKI N G
Choose the function cooking time
The oven is switched on and the pot symbol
Set the end time using the end of cooking button
Use the +/- buttons to set the fi nal time actually required. The oven is switched off and the pot symbol
disappear. The pot symbol will appear again when the time coincides with the fi nal time minus the cooking time.
At the end of the automatic programme the symbol "A" starts to fl ash. The buzzer sounds and the oven and pot
symbol disappear.
10. MIN UT E MI ND E R
Choose the timer function (
remain on for the duration of time set. At the end of this time the buzzer sounds.
11. BUZ Z E R
The buzzer sounds at the end of the cooking time function and continues to buzz for 7 minutes. The buzzer is
silenced by pressing any of the buttons
The volume of the buzzer can be adjusted using the "-" button without having fi rst selected any function.
There are three diff erent buzz volumes to choose from and their duration depends upon the length of time for
which the "-" button is held pressed.
12 . START OF A P R O G R A MME AND CHE CKI NG
Once a programme has been selected it starts after setting the time. The time remaining can be viewed at any
time by selecting the corresponding function again.
13 . IDE NTI F YI N G A P R O G RA MMIN G E RROR
There is a programming error if the time indicated on the clock is between the cooking and end of cooking times.
The error is indicated by the buzzer sounding and the symbol "A" fl ashing.
14. CAN CEL L I N G A P R O G RAMME
To cancel a programme select the manual function. At the end of the set programme this is automatically cancelled.
15. IMM ED I AT E U S E
A) If the display fl ashes read point B, otherwise go to point C.
B) If the display fl ashes the correct time has not been set or there has been a power failure. In this case, set the
correct time (see paragraph 5) and then go to point C.
C) Press the and
knob) using the knobs on the appliance.
and set the required time with the +/- buttons. The symbol "A" appears.
appear. Wait a few seconds until the current time appears.
button) and set the required time with the +/- buttons. The bell symbol
or
button simultaneously. Set the temperature (thermostat knob) and function (selector
@
EL2000 CLOCK/TIMER
Warning: upon switching on forthe tirsi time or whenever there has been a power fai Iure the display flashes. This
means thai the time musi be set.
Setting the time: press the clock button
time using the + and - buttons.
Timer: set the time required with the + and - buttons, bearing in mind thai a maximum of 99 minutes can be set. The
timer advances or reverses 1 o seconds al a time. The beli symbol
end of the set time a buzzer sounds. This continues lo buzz lor 7 minutes and can be switched off by pressing the +
button.
Buzzer: the volume of the buzzer can be adjusted using the - button only when the time is indicated on the
display.
, the approximate fi nal time appears on the display.
.
(9
Set the
[l
remains on lor the entire duration of time set. Al the
19
will
.