Configuring Alarm Input - HIKVISION DS-2DE1A400IW-DE3 User Manual

User Manual of Network PTZ Camera
2. Check Enable checkbox to enable the tampering detection.
3. Click
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configuring Motion Detection.
4. Click
surveillance center, send email and trigger alarm output are selectable. Refer to Section 5.2.1
Configuring Motion Detection.
5. Click

5.2.3 Configuring Alarm Input

Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO (Normally Open)
and NC (Normally Closed).
3. Edit the name in
alarm input (optional).
© Hikvision
Figure 5-15 Tampering Alarm
tab to enter the arming schedule setting interface. The arming
tab to select the linkage method taken for tampering, notify
to save the settings.
45
to set a name for the