Operation Environmental Condition - multicomp pro MP710080 User Manual

Switching mode power supply
Hide thumbs Also See for MP710080:
Table of Contents

Advertisement

Keep this manual in a safe place for quick reference at all times.
This manual contains important safety and operation instructions for correct use of the power
supply. Read through the manual and pay special attention to the markings and labels of this
Pay special attention to these two types of notices used in this manual
Failure to observe this warning may cause injury to persons and damage to power
Failure to observe this warning may result in damage to equipment
WARNING:
1. Do not use this power supply near water.
2. Do not operate or touch this power supply with wet hands.
3. Do not open the casing of the power supply when it is connected to AC mains.
4. Refer all servicing to qualified service personnel only.
5. Before replacing the AC fuse at AC socket, find out and clear up the cause first.
6. Replace the AC fuse with the same type and rating as the original fuse.
7. The max. output voltage of Model MP710081 is 60VDC, avoid touching the metal contact part of the
output terminals.
CAUTION:
1. Use a grounded 3 pin AC source.
2. This unit is for indoor use only.
3. Do not operate or place this unit in a humid, dusty, in direct sunlight location or near any heat source.
4. Before plugging into local AC mains, check with the rating label at the back of the unit.
5. Do not block any ventilation openings of the unit.
6. This unit must be used within the specified rating, regular excessive continuous loading may cause damage to
the power supply.
7. The gauge size of input power cable must be at least 0.75mm
exceed 3m.

OPERATION ENVIRONMENTAL CONDITION

10-80% R.H.
Maximum relative humidity 80% for temperature up to 31°C decreasing linearly to 50% relative humidity at
40°C.
Altitude up to 2000m
Installation category: CAT 2
Pollution degree: 2
Mains supply voltage fluctuation up to ±10% of the normal voltage
USER MANUAL
unit and equipment to be connected.
supply or connected equipment.
and Improper functioning of the power supply.
WARNING:
CAUTION:
2
and the total length of power cable must not

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MP710080 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Mp710079Mp710081

Table of Contents