Installation - Polar Electro GH261 Instruction Manual

EN

Installation

Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation.
If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for
the first time, clean the GN pans (sold
separately) and interior with soapy water
then dry well.
• Level the appliance by adjusting the screw
feet.
Fit Glass Panels
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the collar for the
grub screw faces inwards.
2. Slot the two side panels into the collars, with
the holes in the glass at the top.
Note: Ensure the screw hole furthest from
the edge of the panel goes to the back of
the appliance.
3. Screw a grub screw into each collar to secure
the panels.
Note: Ensure the soft end of the grub screw
is the end making contact with the glass.
Do not over-tighten the grub screws as it
will result in the glass breaking.
4. Slot the rear panel into the collars, with the
holes in the glass at the top.
5. Screw a grub screw into each collar to secure
the panel.
6. Slot the plastic plugs into each of the holes.
7. Screw the brackets to the inside of each pane
using the bolt assemblies.
4
GH261_AB090_ML_A5_v1_20230627.indb 4 GH261_AB090_ML_A5_v1_20230627.indb 4
Note: Ensure the short end of the bolt
assembly is on the outside of the panels.
8. Place the top panel onto the brackets, ensuring
all holes line up.
9. Insert the plugs and attach the top panel to
the brackets with the bolt assembly.
Bracket
Glass Panel
Bolt Assembly
Plug
Bolt Assembly
Optional: Attach Countertop fridge
to counter fridge (Model CN402)
1. Remove the appliance from the packaging.
2. Tip the appliance back and loosely attach the
three brackets to the underside of the counter
top, using suitable screws. Do not fully tighten
at this stage.
Note: Ensure the two 'L' shape brackets are
fitted to the outside edges.
3. Lower the Counter Top unit onto the granite
sides. Ensure the side brackets are postponed
on the inside of the granite rim.
4. Push the side brackets flush with the granite
and tighten the bracket screws.
2023/6/27 15:40 2023/6/27 15:40