Table of Contents
Advertisement
• The calculation you are performing has caused the capacity of the matrix
or vector stack to be exceeded.
Simplify the calculation expression so it does not exceed the capacity
of the stack.
Try splitting the calculation into two or more parts.
Syntax ERROR
• There is a problem with the format of the calculation you are performing.
Argument ERROR
• There is a problem with the argument of the calculation you are
performing.
Range ERROR
• During batch input in the Spreadsheet Mode, input for Range is outside
the allowable range or is a cell name that does not exist.
For Range, input a cell name within the range of A1 through E45, using
the syntax: "A1:A1".
Circular ERROR (Spreadsheet Mode only)
• There is a circular reference (such as "=A1" in cell A1) in the
spreadsheet.
Change cell contents to remove the circular references.
Memory ERROR (Spreadsheet Mode only)
• You are attempting to input data that exceeds the allowable input
capacity (1700 bytes).
• You are attempting to input data that results in a chain of consecutive cell
references (such as cell A2 referenced from cell A1, cell A3 referenced
from cell A2..., etc.) This type of input always causes this error to be
generated, even if memory capacity (1700 bytes) is not exceeded.
• Memory capacity was exceeded because a formula that includes a
relative cell reference was copied, or because of batch input of formulas
that use relative cell references.
Delete unneeded data and input data again.
Minimize input that results in a chain of consecutive cell references.
Shorten the formula being copied or the formulas being batch input.
Before Assuming Malfunction of the
Calculator...
Note that you should make separate copies of important data before
performing these steps.
1. Check the calculation expression to make sure that it does not contain
any errors.
2. Make sure that you are using the correct mode for the type of
calculation you are trying to perform.
3. If the above steps do not correct your problem, press the key.
• This will cause the calculator to perform a routine that checks
whether calculation functions are operating correctly. If the calculator
discovers any abnormality, it automatically initializes the calculation
mode and clears memory contents.
4. Return the calculation mode and setup (except for the Contrast setting)
to their initial default settings by performing the following operation:
(RESET)(Setup Data)(Yes).
25
Advertisement
Table of Contents
