Table of Contents
Advertisement
5. To apply the input, press .
• This inputs =2A1–3 into cell B1,
=2A2–3 into cell B2, and =2A3–3
into cell B3.
To batch input the same constant into a series of cells
Ex 5: Continuing from Ex 4, batch input into cells C1, C2, and C3 the values
that are triple those of the cells to the left.
1. Move the cell cursor to cell C1.
2. Press (Fill Value).
• This displays a Fill Value dialog box.
3. In the "Value" line, input the constant B1×3: (B)3.
4. Move the highlighting to the "Range" line and specify C1:C3 as the
range of the batch input.
5. To apply the input, press .
• This inputs the values of each
calculation result into cells C1, C2,
and C3.
Recalculation
Auto Calc is a setup item. Depending on the content of the spreadsheet,
auto recalculation can take a long time to complete. When Auto Calc is
disabled (Off), you need to execute recalculation manually as required.
To perform recalculation manually: Press (Recalculate).
Errors
The calculator will display an error message whenever an error occurs for
any reason during a calculation. While an error message is displayed, press
or to return to the calculation screen. The cursor will be positioned
at the location where the error occurred, ready for input.
To clear the error message: While an error message is displayed, press
to return to the calculation screen. Note that this also clears the
calculation that contained the error.
Error Messages
Math ERROR
• The intermediate or final result of the calculation you are performing
exceeds the allowable calculation range.
• Your input exceeds the allowable input range (particularly when using
functions).
• The calculation you are performing contains an illegal mathematical
operation (such as division by zero).
Check the input values, reduce the number of digits, and try again.
When using independent memory or a variable as the argument of a
function, make sure that the memory or variable value is within the
allowable range for the function.
Stack ERROR
• The calculation you are performing has caused the capacity of the
numeric stack or the command stack to be exceeded.
24
Advertisement
Table of Contents
