Installations; Spacer Kit Installation (For Microwave Ovens) - Jenn-Air JMC2427LL Owner's Manual

A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
Electrical Connection
To properly install your microwave oven, you must determine the
type of electrical connection you will be using and follow the
instructions provided for it here.
� Microwave oven must be connected to the proper electrical
voltage and frequency as specified on the model/serial/rating
plate. The model/serial/rating plate is located underneath the
control panel along the oven vent.
A.
Model/serial/rating plate
� The microwave oven rated 120/240 V, 20 A, has 4 wires (L1,
L2, N, and G) in the flex conduit, and should be connected to a
20 A maximum-rated circuit, overcurrent protected on both the
L1 and L2 circuits.
� A time-delay fuse or circuit breaker is recommended.
� Flexible cable from the microwave oven should be connected
directly to the junction box.
� Do not cut the conduit. The length of conduit provided is for
serviceability of the microwave oven.
� A UL listed or CSA approved conduit connector must be
provided.
� If the house has aluminum wiring, follow the procedure below:
Connect the aluminum wiring using special connectors and/or
tools designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with local
codes and industry accepted wiring practices.
For power requirements, refer to the following table:
Voltage
240 VAC
208 VAC
6
Microwave With Convection
Oven
19.9 A/3250 W
19.9 A/3250 W

INSTALLATIONS

Spacer Kit Installation (For
Microwave Ovens)
NOTE: The microwave oven spacer kit allows the microwave
oven to be installed in an 17
maximum cutout height.
Assemble Spacer Kit
1. Attach the bottom vent to spacer bars using four 3/8" (9.5 mm)
hex-head washer screws.
NOTE: Spacer bar flanges should be facing out.
A.
Bottom vent
B.
Spacer bar flange
C.
Spacer bars
D.
3/8" (9.5 mm) hex-head washer screws
Install Spacer Kit
1. Center assembled microwave oven spacer kit against lower
front edge of the cabinet cutout.
2. Using an 1/8" (3.2 mm) drill bit, drill through the mounting
holes in the spacer bars to create pilot holes.
3. Attach the assembled spacer kit to the cabinet using four
3/4" (1.9 cm) (pan-head screws). Do not overtighten screws.
A.
3/4" (1.9 cm) flat-head screws
B.
Spacer kit assembly
3 / " to 17 3 / " (44.1 cm to 45.1 cm)
8 4