Table of Contents
Advertisement
Available languages
Available languages
INSTALLATIONS
Spacer Kit Installation (For
Microwave Ovens)
NOTES:
■ The microwave oven spacer kit allows the microwave oven to
be installed in an 17
7
/
16
maximum cutout height.
■ If your cabinet cutout height is more than 17
must install the spacer kit. Proceed to "Assemble Spacer Kit."
■ If your cabinet cutout height is less than 17
do not have to install the spacer kit. Proceed to "Prepare
Built-In Microwave Oven."
Assemble Spacer Kit
1. Attach the bottom vent to spacer bars using four 3/8" (9.5 mm)
hex-head washer screws.
NOTE: Spacer bar flanges should be facing out.
A. Bottom vent
B. Spacer bar flange
C. Spacer bars
D. 3/8" (9.5 mm) hex-head washer screws
Install Spacer Kit
1. Center assembled microwave oven spacer kit against lower
front edge of the cabinet cutout.
2. Using an 1/8" (3.2 mm) drill bit, drill through the mounting
holes in the spacer bars to create pilot holes.
3. Attach the assembled spacer kit to the cabinet using four
3/4" (1.9 cm) ( flat-head screws). Do not overtighten screws.
A. 3/4" (1.9 cm) flat-head screws
B. Spacer kit assembly
" to 17
7
/
" (44.1 cm to 45.3 cm)
8
7
/
" (44.1 cm), you
16
7
/
" (44.1 cm), you
16
Prepare Built-In Oven
1. Decide on the final location for the oven. Locate existing
wiring to avoid drilling into or severing wiring during
installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the Microwave Oven or Oven onto
cardboard prior to installation. Do not use handle or any
portion of the front frame for lifting.
3. Remember to remove bottom vent from the foam packing on
top of the Oven.
4. Remove the shipping materials and tape from the Microwave
Oven or Oven.
5. Remove the hardware package from inside the bag containing
literature.
6. Remove and set aside racks and other parts from inside the
Microwave Oven or Oven.
7. Move Microwave Oven or Oven and cardboard close to the
oven's final location.
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 12 gauge copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death,
fire, or electrical shock.
The microwave oven is manufactured with a neutral (white) power
supply wire and a cabinet-connected green (or bare) ground wire.
1. Disconnect power.
2. Feed the flexible conduit from the oven through the opening in
the cabinet.
3. Remove junction box cover, if it is present.
4. Install a UL listed or CSA approved conduit connector to the
junction box.
A. UL listed or CSA Approved conduit connector
5. Route the flexible conduit from the oven to the junction box
through a UL listed or CSA approved conduit connector.
7
Advertisement
Table of Contents
