Table of Contents
Advertisement
NOTE: Linking mode lasts for 12 seconds; if no signal is received from a
remote handset during this time then the Plug-in will automatically exit
linking mode without linking the device.
If, when expecting a quick flashing blue LED to confirm pairing, a slow
amber flash is received instead, then the Plug-in memory is FULL and no
further remotes may be linked with it unless one of the existing remotes is
unpaired first (see below).
Unlinking remotes and clearing the Plug-in memory
Removing a single Device:
1. On the Plug-in, press and hold the
Manual button until the LED flashes blue
and amber alternately, and then release it.
The Plug-in is now in linking mode.
2.
On the controller press the button that
you intend to link. If using the Smartphone
or Web App, press the 'connect' button
(the App instructions will guide you
through this). The LED will flash blue to
confirm that the remote is now linked.
Device Setup
Advertisement
Table of Contents
