Far Tools LL 1400E Original Manual Translation page 19

SCIE CIRCULAIRE
EN
Règle spécifique de sécur
c ) Ensure that the soleplate of the saw will not slip when
making a "downward cut" when the blade bevel is not
adjusted to 90°.
If the blade slips, it will seize and kick back
d ) Always check that the guard is covering the blade before
putting the saw down on a workbench or the floor.
A blade which is no longer protected, and whose inertia
means that it is still spinning, will force the saw backwards
and cut everything that is on its trajectory. Be aware of the
time necessary for the blade to stop after the switch has
been released.
e) Use only blade diameters consistent with markings.
f) The power and quality of the cut depends largely on the
state, the number and shape of the teeth of the saw blade.
Use only saw blades sharp and appropriate materials to
work.
The original blade is used on the wood. Specific blades for
SCIE CIRCULAIRE
cutting plastic are commercially available.
g) Adjust the feed rate to the nature and thickness of mate-
rial being cut. A rate too high can cause overheating of the
Règle spécifique de sécurité
blade holder and a heating of the merger see if it is plastic.
< 5 mm
Additional safety instructions for all saws with board split-
ter
a ) Use the board splitter that is suitable for the blade being
used
For the board splitter to work, it must be thicker than the
blade body, but thinner than the teeth of the blade.
b ) Adjust the board splitter in accordance with the informa-
tion described in the instruction manual
Incorrect spacing, positioning and alignment can prevent
the board splitter from preventing kickback
c ) Always use the board splitter except for a downward
cut.
The board splitter must be replaced after a downward cut.
The board splitter interferes with a downward cut, and can
cause kickback.
d ) For the board splitter to function properly, it must be
pushed into the piece you are working on
The board splitter does not prevent kickback during short
cuts
e ) Do not use the saw if the board splitter is twisted
< 5 mm < 5 mm
Even slight interference can slow down the speed at which
the guide closes.
Particular Manual Circular Saw-7L-F.indd 14 07/07/2017 15:59