Integrated Columns - Wine Cabinet - Fisher & Paykel RS2484VR2K1 Installation Manual

Integrated columns wine cabinet
Hide thumbs Also See for RS2484VR2K1:
Table of Contents

Advertisement

Available languages

Available languages

SAFETY AND WARNINGS
INSTALLATION
Cavity preparation
The anti-tip bracket and fittings supplied must be fitted to the wall of the finished
enclosure to withstand a 225lb/100kg load.
Ensure that the anti-tip bracket is installed correctly to prevent the possibility of the
appliance tipping forward when the door is open.
Positioning inside the cabinetry
DO NOT attempt to open the door until the appliance is fully installed.
Ensure the door of the appliance is closed when rolling into the cabinetry.
Ensure the power cord is not run over or damaged when rolling the product
into the cabinetry.
Aligning inside the cabinetry
Ensure the doors are in line with the cabinetry front and the appliance is centred.
All four corners of the appliance must be supported firmly onto the floor to eliminate any
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Fixing inside the cabinetry
Use low speed, low torque setting when using a powered driver for the screws when fixing
or aligning the product.
Make sure to remove the depth alignment brackets before fixing the appliance inside
the cabinetry.
Open the appliance door to remove the alignment brackets from both sides of the
appliance, and then re-tighten the screws.
Door panel installation
Stainless steel
Protect the finish of the Fisher & Paykel Stainless Steel door panels from any
scratch or damage.
Leave the protective film on the panels when hanging and remove the film only when the
installation is complete.
Custom
If using Custom door panels, ensure they are prepared as per 'Custom door panel
dimensions' section.
Ensure the screw pilot holes do not penetrate the full depth of the panel.
Do not place the handle holes in marked areas to avoid clashing with panel
attachment brackets.
Minimum panel thickness where screw hole is drilled must be 16mm.
Door hinge change
Door hinges are interchangeable for each model. A hinge change kit is available
and can be purchased separately if you prefer to change from 'right hand hinge' to
'left hand hinge' or vise versa.
INTEGRATED COLUMNS — WINE CABINET
RS2484VR2K1
RS2484VL2K1
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rs2484vl2k1

Table of Contents