Tools
Moving the sensor housing
T2 star-head
screwdriver
Flat-head screwdriver
OPTIONAL — CHANGE DOOR HINGES
A
1
Unclip the reed switch
from the housing (A).
D
4
Move the sensor housing so that the
opposite reed switch clip is aligned
with the centre of the cabinet (D).
E
5
Reinstall the sensor housing using
#8x16 screws (2x) into the pre-drilled
holes in the cabinet top panel (E).
B
2
Unhook the interceptor board harness
from sensor housing so harness
is loose (B).
F
6
Clip the reed switch into the sensor
housing in the pocket closest to the
centreline of the cabinet (F).
C
3
Remove the #8x16 screws (2x) from
the sensor housing (C).
G
7
Press the harness from the
interceptor board into the forks on
the sensor housing (G).
43